 |
| hcs |
HCS excellence
Power / torque increased vehicle so that the gas which is shorter footing can obtain better acceleration than before. Peak torque can be obtained at a lower rpm.
When the power / torque we use it wisely, it is expected to earn fuel savings between 15-30% in the car Injection and that a higher percentage in car carburetor. It was reported also for Jupiter MX bike can save 100%.
Of the few times the emissions test dg HCS method of non-active and active in a variety of vehicles such as Luxio, Innova, Avanza and baleno, then seen a decrease in the levels of HC and CO when HCS is active. Provided that when opening the faucet HCS also noticed a change in the monitor lambda.
In some cases it is reported that air-conditioning temperatures colder than before so that the temperature level had to be lowered.
After a few months of usage in the test vehicle (avanza, GranMax, and innova) who use premium gasoline color spark plugs look like using 92/95 octane fuel.
When AFR / lambda raised above 1, the savings could be even higher without reducing power.
Does not require electrical power and easy to install / remove without damaging the existing vehicle components.
The catalyst can be used up to 4000cc engine size. In the United States ever tested in Durango cars with 5700cc capacity and there is an increase in power and a bit of saving as well as in Indonesia ever installed in Chrysler MPV dg 3000cc capacity with the same results. Can for petrol and diesel engined vehicles (different catalyst).
weakness HCS
For those who could not make a serious hassle of having to look for openings faucet that is right for their vehicle to gain power and fuel efficiency. As well as filling the tube. Standard tube which is filled max. 700cc
Period / distance use is relatively short for some people. 700cc usually have to be replaced when it is a distance of 150km for 3-4 days in the city or which one is first reached. For out of town to a distance of 175km.
When that sucked the gas liquid (because the contents of the tube past the max limit or passing through a bumpy road) will cause the engine mbrebet because too much fuel into the combustion chamber. However, it will not damage vehicle components and systems HCS.
When opening the faucet is too big, then the vacuum will drop. In the car Injection results are not good because the MAP sensor to report the additional burden that will increase the frequency of the injector to spray fuel. So do not get gasoline savings could be even more extravagant than at first though to get even bigger power.
Openings are too large will also accelerate the shrinking of the contents of the tube. Usually depreciation or decline in gasoline octane quality characterized by declining vehicle performance compared to current high-octane gasoline still.
For some users often are not aware if the contents of the drum is empty. When this happens you should immediately close the valves in the tube and faucet airmix (special carburetor) to return the vehicle under normal circumstances (such as before using HCS) and to prevent wasteful consumption of gasoline is due to the vacuum decreases.
Other things.
When the tube contents mixed with water gas does nothing throughout the volume of water does not reach the maximum limit of the contents of the tube so as not to be sucked directly by the engine. If mixed then that will expire first are the gasoline because it is more volatile and always being on the water because the density of water is greater than the gasoline.
Water can also be used but is not effective. But when in use boiling water vapor and steam combined with fuel before entering the catalyst, so if the right will make hydrogennya volume increased to a hydrogen rich, or a better hydrogen. Can be checked through the emissions test.
