Chain Motor Sets Own Way

1 It should be recognized that each of these types of motors have different characters, including the affairs of the chain earlier. For that read carefully motorcycle owner's manual and understand the parts related to the motor so as not to confuse the current chain tighten / loosen the chain.
2 Before adjusting the chain, position your bike in the standard position (jack) is. It is intended that the position of the rear wheels can rotate freely. Find the position of the chain adjustment by way of playing then find the highest point of the chain. Because the chain is worn out his conditions are very different, there was at one point being at point saggy once another very strong position.
3 After that loosen the wheel bolts and pull the wheel back a few millimeters and slowly tighten the bolts again, to check the chain tightness. Measure the distance tenuous chain by pressing the bottom with your fingers or a screwdriver. Distance tenuous chain of normal driving range 20-33mm (or can be seen on the sticker on the lid chain wheel). Chain that is too tight will quickly wear out, otherwise if slack will cause excessive jolt and vibration.

4 Do not forget to turn off the mark chain adjustment settings between the left and right of the sign must be the same position. Similarly, make sure the sprocket (gear) front and rear sprocket should remain parallel. Because if it is not the same as this may damage the chain sprocket even his.
5. If all this is done, make sure the rear wheel while tightening the bolt, the wheel does not move at all, as if the slightest shift will have a huge impact on the tone chain.
6 It is advisable to check the tightness of the chain at least once every two weeks so that safety and driving comfort is guaranteed, especially if the motor is often used to travel. If you are not sure I can do the steps above, it's good to bring the motor to a repair shop or ask for help they are more expert.