HCS Installation Method in Vehicle

HCS Installation is very simple because it only needs 3 points for the placement of the device, namely:
1 Install the tube
The tube is placed in such a way in order to function and do not affect the motorcycles. Can be placed in the trunk of a broad or make an adapter outside motorcycle cover. Able to install the box.
2 Installing catalyst
The catalyst was placed around the machine that has enough heat in order to function properly. Adequate places for the catalyst is directly attached to the exhaust, the exhaust on the cover, in the waterway made ​​of iron, or in the engine block.
3 Connecting to the driveway
Look pathways exist around the intake manifold. Usually there under the carburetor or throttle body after. If no yes take it to the repairman and asked for the entry lane. Usually the motor is Honda Grand, Astrea etc.. Another way is to buy a new intake because there is a direct variation. Do not use the vacuum lines connected to the gas tap.
Having already installed neatly next step is setting. How does the setting?
Turn on the machine and wait 3-5 minutes for the machine under normal conditions and temperatures hotter exhaust catalysts in order to function optimally. Then exaggerated suits rpm up gas to approximately 1000rpm. Open faucet tube to exit the bubble and the rpm decreased approximately 500rpm. Open faucet until the rpm climb back airmix approaching its original position. Shrink gas suits up to the desired idle.
After doing the test wrong way. Feel the power if there is a change in your vehicle. When it appears HCS overall installation is already completed.