Inside Carburetor

Carburetor parts has its own purpose or function. Part of this section also are interconnected and can not be separated from one another. as our body can not move without oral cavity, the cavity useless without teeth, the teeth do not function without the tongue.

So in these parts are interrelated and interdependent. many are indifferent in one part carburetor and know the purpose or function of the part in the carburetor. little mistakes sometimes make bad motors. The carburetor can be compared with our oral thrush mulut.jadi when it is difficult to eat something too right. The carburetor was also the same if there is the slightest error and the effect it will mbrebet also into the machine.



1 Buoy

This is the task of maintaining a float altitude of gasoline in the carburetor bowl. if the amount exceeds the limit of the effect of fuel mixture will become fat and fuel consumption will be more extravagant. in these circumstances can actually be overcome by adjusting the height buoy want bin fat or skinny.

2 Skep Needle

needle set here working with the needle jet is set bursts of gas into the combustion chamber. if the part is worn, the mixture of air and fuel jets ideal.needle not located under the needle skepticism or hole into which it can be said needle skepticism. to remove it sometimes must be struck.

3 Needles float.

This part relates directly to the buoy because it was coupled with a float. function of this float needle to seal gas channel in the carburetor bowl when the float has moved up and make a float needle closes the fuel inlet. This material is usually in the form of a layer of rubber on the end and there is also an iron. if the float needle tip wear or any of its channels also can certainly be a bowl of gasoline flooding.

4 Pilot jet

part that serves the air fuel mixture at low engine speed to medium. The most important part after the main jet.

5. Main jet

part attached to the main jet holder are located inside the carburetor and under the needle skepticism. serves the mixture of fuel and air from the engine rev up to lap up the middle.

6. choke system

tool to increase the gas mixture into the combustion chamber. intended to be live when the engine is cold machine state. This part attached to the carburetor. and there is also a cable pull from the left hand grip.