Today many users want the motor to increase motor performance, but still economical fuel consumption at a low cost. Actually there is a good way, that is by maximizing the standard components and some standard modifications without damaging the part.
Before doing these tips, you should first make sure that the motor you all in good health. This is so that the performance can be much more leverage (correct carburetor settings, clutch fitting suits, etc..). Here I apply a few cheap tips to add acceleration and performance of the motor.
1 Make a ground strap on spark plug wires
Ground strap on the spark plug wire serves as a part that captures stray currents that occur due to the high voltage induced in the coil. We can focus the flow of current to the spark plugs and make no where. How to create a ground strap. The effect is better ignition quality, because the spark plugs fire focused and strong. Fuel can be burned more completely and lower emissions. As a result better performance.
 |
| ground strap on my bike |
HCS, short hydrocarbon Crank System, is an efficacious product for mengiritkan fuel consumption. Certainly the performance of the motor increases, especially in the run-down (low RPM) are often stuck in traffic. The pull of powerful and economical.
3 Porting polish itself
Ported polish is meant only improve exhaust flow and the induction process. Provide a rough piece of sandpaper half and patience. Rub the sandpaper on the surface of the inlet and exhaust ported to the original orange peel disappear. At the inlet much as possible not smoothed (polish) as slippery as glass. Let a little rough sandpaper of his former course. Ported on the exhaust as slippery as glass can be polished up to a maximum residual exhaust gas. Rub Autosol or something until smooth. The result, do not be afraid because it is not true origin be wasteful process.
4 Modification of air filter
The air filter must be kept clean so that the air intake is not obstructed. In order to get a better air intake, try scissors / razor several places about the size of a box-shaped 2 x 2 cm. It is intended that the air sucked into the engine faster, but still filtered air filter. If you want gentlemen off without removing the air filter and filter box so that no particles / foreign matter from entering. It's just that there is a risk of this trick, which is that until the dust entering the engine so quickly dirty and need cleaning routine.
 |
| modif little |
The compression ratio can be raised slightly by the method block off gasket piston associated with the crankcase. In place of the gasket, you can use liquid glue threebond or create a thick paper gasket with a thinner (0.1 mm paper calendar). To increase the compression ratio of the engine can still use premium fuel for standard compression ratios below 10: 1.
