Make her Lamellar Flywheel (as shown above) with a diameter of slab = 112 mm and length = 38 mm bulge or CDI fit to be used.
Note:
Measured when the piston is at Top Dead Point (TMA)
If the diameter of 112mm and a 1.5 mm thick bulge, then 1 mm = 1º
example:
- Engine idling at 15º before TDC
- Maximum ignition angle BTDC = 53.0º
application:
If you are using CDI BRT Hyperband Karisma models with code 15-35, which means:
- Idle = 15º
- Advance = 35 º
Its factors:
Curve ignition (ignition timing curve) of a machine is determined by several factors, namely:
Type of fuel
The shape of the combustion chamber
Stride length (stroke)
Nokens As (Cam Shaft)
Comparison of Compression (Compression Ratio)
- Engine idling at 15º before TDC
- Maximum ignition angle BTDC = 53.0º
application:
If you are using CDI BRT Hyperband Karisma models with code 15-35, which means:
- Idle = 15º
- Advance = 35 º
Its factors:
Curve ignition (ignition timing curve) of a machine is determined by several factors, namely:
Type of fuel
The shape of the combustion chamber
Stride length (stroke)
Nokens As (Cam Shaft)
Comparison of Compression (Compression Ratio)
