Make Jet Auxiliary Power Round Up

Existing pathway, can directly penetrate

The rise of 500 meters straight track racing, tend to force the engine to play on high rotation. Support fuel, must be qualified. Here's a trick that can be relied upon to remain perfect running fuel. That is, apply power jets in the carburetor.
If in the run-down, yet the road. Because of the power jet will work as bottle opener skepticism. When skepticism held high, fuel will be sucked vacuum snout carburetor.

Create a buddy that applications such as Keihin PE, is actually in the carburetor is already available paths to power jets. So, staying utilized alone. Indeed there is, but its function is not as much if we use additional tools. For example, like slang.
Why not optimal? Due to the presence of slang and the increasing length of the hose, then the supply of gasoline for the longer lap top. Differences with the only advantage carburetor lines only. But what baseball. After all steps that we want to do this, low-rousing know. Just drill and glue capital alone.
How:
1 Know first lines or channels that could be used to power the jet.
The path in the carburetor bowl and the body side. However, this channel is in a closed state. Then it needs to be punched.
The drill is used, devices commonly used for nozzle reamer. In one set or its packaging, is available ranging in size from 0.3 to 1.6 mm. But, in this case use the 0.8 mm only. The hole should not be too small or too large, too. If it is too large in fact there is no back pressure. Besin so baseball up. If too little is also not optimal.

2, Make holes existing path hand side of the carburetor (fig. 1).
This path, make a pathway from the bowl. Once perforated, closed hole surface wear iron glue. Then, proceed to the venturi tembuskan. If it is, close it again to use glue iron in surface hole (fig. 2).
Now, the body was translucent. Staying on the track to make a bowl. Use a drill bit the same, now tembuskan existing path at the end of the bowl. But, in order to fill the gas lines of the bowl, then the path should be copied (fig. 3).

Because it is impossible drill from the side in a bowl then drilling technique should be done from the outside because of space to position the drill bit limited. Then it must be from the outside. If it is translucent, do not forget the outside of the already drilled it closed to use glue. Finish all the processes are carried out, living raft and re-plug the carburetor. Now, feel the difference.