Removing the way Resistor Spark Plug Cop

Removing the way Resistor Spark Plug Cop Did you know that the voltage supplied to the spark plugs are not all intact, and many were wasted. For example, the coil voltage power delivered at the spark plug 10.000V not get that much, why is that?
It turns before reaching the current passes through the spark plug wires, spark plugs and spark plugs then cop itself, each of these components is equipped resistant, consequently the output voltage of the coil was reduced significantly, do not believe? Please measure yourself. Measure the resistance of the spark plug using a multitester cop, it turns out the average resistance cop plugs in numbers ranging from 10 Kilo Ohm, Busi was also the same spark plugs as well as wires.
The manufacturer deliberately gave this resistance for the sake of durability and antistoring ignition components, is by storing the anti dampen wave impedance is frequency. If the leak will disrupt the TV waves, car audio systems, even a fairly high frequency waves can damage the ECM (engine control module injection).
Removing the spark plug resistance is not actually forbidden to do, it feels about the disturbing frequency does not affect much on the motor, but the motor is fitted with an audio device like a motorcycle contest, specifically for injection motor as the Yamaha V-Ixion, Supra X 125 PGM-FI, and FI Shogun this way was forbidden, because it would damage the ECM that is in the motor, so do not try. However, for the motor that still uses a carburetor system is a very effective way because of the fire at the end of the spark plug becomes greater fuel burn completely automated, economical and energy increased. If Brother or Sister wants to see resistant release the following way:
Tools and materials:

     Iron saws
     Iron Glue or Super Glue
     Nails, bolts, or pieces of iron (Replacement Resistor)

  
How it works:
1 cop plugs Saws

Cop resistance in the common spark after spark plug wires attached her to head towards the spark plug, to remove the plugs stay sawing cop (Figure 01). Usually after sawed resistor will jump out because there per in it. When finished sawed a small circle will appear (Figure 02) is called resistance (Resistor)

2 Replace the resistor with iron
This resistor is removed so just stay then replace the long irons the size (Figure 03), can of bolts or nails, which is important not too big let me get into the hole cop spark plugs, pernya be discarded or used again also not a problem.

3 Restore condition and affix with glue
Once the input is replaced with iron replacement pieces back former cop spark plug (Figure 04) then glue using glue or super glue other iron, wait for it to dry about 1 hour, then plug it into the motor, feel the difference!

For already installed racing coil, coil car, coil Special Engine, the maximum result though more cable replace spark plugs use a red audio cable (Figure 05) which is commonly called the Sound Stream Power Cable spark plug wire luggage because there are still small even though its resistance spark plug wires racing like Splitfire, NGK, or Red line is still a little resistance around 900 Ohm.