CVT automatic motor components in the front-rear wide pulleys and V-belt must be free of dirt. If dirty it will cause impaired his performance. So must be diligently cleaned. The cause can also be easily attached dirt from oil seepage. If so, not enough hygiene measures. Must be tracked cause. Oil was also being bothered working CVT components, in addition to slick, oil can run out of the edges quickly broken machine.
It was caused by several things, which is often blamed its oil seals. Sil CVT itself there are 2 grains. First sil crutch-as lying behind the roller (front pulley / primer). Secondly, seals rear axles pulleys / double lining behind the pulleys earlier. Live area see under the second seal is located.
Tensioner bolt can be glued
The entry of oil into CVT area could also bolt cam chain tensioner retaining tongue. It is located behind the house at the top of the roller or sil crutch-as earlier. So kudu diperhatiin also include o-ring bolt kindisi earlier, if the o-ring it brittle or damaged yes gentlemen replaced. But if the condition is quite topical okay with gasket / gasket glue and reinstall.
It was caused by several things, which is often blamed its oil seals. Sil CVT itself there are 2 grains. First sil crutch-as lying behind the roller (front pulley / primer). Secondly, seals rear axles pulleys / double lining behind the pulleys earlier. Live area see under the second seal is located.
Tensioner bolt can be glued
The entry of oil into CVT area could also bolt cam chain tensioner retaining tongue. It is located behind the house at the top of the roller or sil crutch-as earlier. So kudu diperhatiin also include o-ring bolt kindisi earlier, if the o-ring it brittle or damaged yes gentlemen replaced. But if the condition is quite topical okay with gasket / gasket glue and reinstall.
bolt tensioner - Crutch-as shaky
There is also a new case is found. After changing seals and o-rings, the oil is still too runny. Quizzed had inquired as crutches arm motion apparently was not alias roll center is the cause. Automatic rubber seals between the side arms do not average.
shaky crutch
cause the seals not meeting - Sil crutch-as
Crankshaft seals withstand engine oil. The pressure in the combustion chamber will cause the oil pushed out. If the seal is worn, then the oil will easily come out.
as crutches seals need checking - Sil rear CVT
Sil on CVT rear axle should be able to prevent the oil out. Stay visible only if there is seepage of oil on the back of the CVT.
sil gear axles need care
